Remove the cutter in your hand, that it is between the thumb and forefinger to lying and that the prism down. To improve the lateral support, the cutter can be further clamped between the middle finger and bale. Now lay the pipe or rod into the prism and press nunIhr pipe or rod into the prism and press the wheel cutting head to the material. Misjudged the Schneider nicht.Drehen the material as possible without
sell quickly at 360 Grad.Achten you that do not cut spiral and the cutting pressure is large enough,
to carve the material evenly. Avoid definitely the Nachscneiden in an existing cutting track, because it is subject to the wheel of extreme wear.
In dry areas, it is necessary to moisten the cut something, so that the micro-corrosion takes.
Experience shows that it takes 2 - 3 seconds until noise suggests the bursting of the pipe. Now, the material can be
break apart by pulling gently.
Deutsch
English